Machining
IMR, Inc.'s machining equipment includes:
- Four boring mills ranging from 48" vertical X 60" horizontal to 96" vertical X 144" horizontal travel
- Blanchard grinder with 83-1/2" table
- Crankshaft grinder with 139" centers
- Engine lathe 52" swing X 288" centers
- Four additional smaller lathes
Portable machining capabilities
- Portable milling and line boring equipment
- Portable key cutting equipment
- Journal Squirrel equipment
- Magnetic drilling units
-
A new 4140HT Backshaft being ground to finish.
This new crankshaft is being roughed out of a Steel Billet before being sent to the grinder for finishing.
-
The face of this steel bolster plate is being facemilled for flatness.
The roller shown is being ground to a cleanup size.
The Niagara flywheel was machined to adapt wider bearings.
